Operation
45
Pos: 53.1 /Überschriften/Überschriften 1/A-E/Bedienung @ 0\mod_1199789505403_78.docx @ 34825 @ 1 @ 1
8 Operation
Pos: 53.2 /Überschriften/Überschriften 2/U-Z/Von Transport in Arbeitsstellung @ 2\mod_1202466185276_78.docx @ 59662 @ 2 @ 1
8.1
From transport into working position
Pos: 53.3 /BA/Sicherheit/7. Gefahrenhinweise alt/Vorsätze/Gefahr - Absenken des Vorsatzes @ 15\mod_1232708075710_78.docx @ 176250 @ @ 1
Danger! - Lowering the machine into working position
Effect: Danger to life, injuries or damage to the machine.
•
Do not lower the machine until you are absolutely sure that neither persons, animals nor
objects are in the swivel range of the machine.
•
Keep persons out of the danger zone. If persons do approach the danger zone, turn off the
machine immediately.
•
Never leave the machine running unsupervised.
•
Check the safety devices each time before the machine is used. Replace damaged safety
devices immediately.
•
Do not work on the front attachment until the engine has been stopped and the ignition key
has been removed. All operating levers should be in the neutral position and no hydraulic
lines should be under pressure.
•
Always check the attachment before use and after driving into an obstacle. Worn, damaged
or deformed blades must be replaced immediately. This also applies to holders.
•
Do not switch on the drive until the front attachment is in the working position.
Pos: 53.4 /BA/Bedienung /Vorsätze/Schneidwerk/Arbeitsstellung X-Disc 620 @ 336\mod_1430201826316_78.docx @ 2559295 @ 3 @ 1
8.1.1
Working Position
Fig. 20
Lower the cutting system (1) down to the ground.
Note
•
Check guard cloth (2) and rubber strip (3) (right-hand and left-hand machine side) before
every use. Replace damaged safety devices (2, 3) immediately.
Pos: 53.5 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1