Kramer Electronics Ltd.
VP-554X
– Connecting VP-554X
10
7. Connect the audio outputs:
▪
AUDIO OUT 5-pin terminal block connector
(1 to 4) to an analog stereo audio
acceptor (for example, a power amplifier/active speakers).
▪
MONITOR OUT line out 5-pin terminal block connector
to active speakers.
▪
SPEAKER OUT
4-pin terminal block connector to speakers.
Connect to
a pair of loudspeakers, by connecting the left loudspeaker to the “L+” and
the “L-” terminal block connectors, and the right loudspeaker to the “R+” and the “R-”
terminal block connectors.
Do not Ground the loudspeakers.
8. Connect the:
▪
RS-232 EXT CONTROL 3-pin terminal block connector
port to an RS-232
controlled device to control it via commands sent from the
VP-554X
.
▪
RS-232 CONTROL 3-pin terminal block connector
port to a PC to control the
unit.
9. Connect the MUTE 2-pin terminal block contact-closure remote-control pins to a switch
to mute/unmute the audio output by momentarily pressing the switch (not shown in
).
10. Connect the ETHERNET port
(on the front panel), DATA port
and/or CONTROL
port
(on the rear panel), to the Network (see
11. Connect the power cord to the power socket.
Connecting the Output to a Balanced/Unbalanced
Stereo Audio Acceptor
The following are the pinouts for connecting the output to a balanced or unbalanced stereo
audio acceptor:
Figure 4: Connecting to a Balanced Stereo Audio
Acceptor
Figure 5: Connecting to an Unbalanced Stereo Audio
Acceptor
30
30
31
19
20
14
21
22
