Kramer Electronics Ltd.
VP-554X
– Operating and Controlling VP-554X
23
Setting HDCP
VP-554X
enables setting the HDCP on the outputs and on the inputs the via the front panel
MENU buttons.
The HDCP is set only for the output that is selected (via the front panel OSD SELECT
button) to show the OSD and for the selected input.
To set the HDCP on the inputs and outputs:
1. On the front panel press
MENU
. The menu appears.
2. Click
ADVANCED
and define the HDCP parameters according to the information in the
following table:
Menu Item
Function
HDCP ON
OUTPUT
Select FOLLOW OUTPUT (default) or FOLLOW INPUT on HDMI OUT.
Select FOLLOW OUTPUT (recommended) for the scaler to match its HDCP
output to the HDCP setting of the acceptor to which it is connected.
Select FOLLOW INPUT to change its HDCP output setting according to the
HDCP of the input (recommended when the output is connected to a
splitter/switcher).
INPUT HDCP
Set HDCP support ON (default) or OFF.
Note that:
1. HDCP must be enabled (ON) to support HDCP encrypted sources.
2. Sources such as Mac computers always encrypt their outputs when
detecting that the sink supports HDCP. If the content does not require
HDCP, you can prevent these sources from encrypting by disabling
(OFF) HDCP on the input.
3. Press ENTER.
HDCP is set on the input/output.
Setting Sleep Mode
Auto Sync Off turns off the output after a period of not detecting a valid video signal on the
input(s) until a valid input is again detected or any keypad button is pressed.
VP-554X
enables configuring the Auto Sync Off delay time when a connected display enters
sleep mode.
To set Auto Sync Off:
1. On the front panel press
MENU
. The menu appears.
2. Click
ADVANCED
and select
AUTO SYNC OFF
.
3. Define Auto Sync Off according to the information in the following table:
Menu Item
Function
Disable
Leave outputs active always.
FAST (10s)
Disable outputs after ~ 10 seconds of no input detection.
SLOW (120s)
Disable outputs after ~ 2 minutes of no input detection.
IMMEDIATE
Disable outputs immediately when there is no input detection.
4. Press
ENTER
.
Sleep mode is defined.
