Korg PA80, User Manual

Page: 161 / 308

16-11 Global edit environment
Page 20 - Vocal Setup 3
PA G E 20 - VOCAL S ETUP 3
Note: This page appears only if you selected Mode = Vocal on
“Page 17 - Vocal/Guitar Mode”.
In this page you can assign a chorus, delay, or reverb effect to
the FX1 and FX2 processors.
FX 1
Effect processor 1. You can assign a Chorus or a Delay to this
processor.
Chorus
A Chorus is a modulating effect, adding a sense
of depth to the sound. Speed sets the modulat-
ing speed, while Depth is the efficacy of the
effect on the sound. Level is the general level of
the effect.
Delay The Delay is a fading-out repetition of the
sound. Use Feedback to set the number of rep-
etitions, Time for the speed of the delay, Level
to set the general level of the effect.
FX2
Effect processor 2. You can assign one of two Reverbs of dif-
ferent sizes to this processor.
Hall, Room
Reverbs of different sizes. Use the Tone param-
eter to program the high-frequencies decay
(higher values mean a more reflective room).
Time sets the Reverb’s decay time. Level is the
general level of the effect.
PA G E 1 8 - G UITAR S ETUP 1
Note: This page appears only if you selected Mode = Guitar on
“Page 17 - Vocal/Guitar Mode”.
In the Guitar Setup 1 page, you can select a Tone (EQ) and a
preamp effect.
Tone
The Tone effect is a 3-band equalizer. Use it to tweak the
sound quality, by boosting/cutting frequencies.
Drive
Drive processor. You can assign a Compressor, Overdrive or
Distortion effect to this processor.
Overdrive
The Overdrive effect simulates the preamp sat-
uration of a tube guitar preamp. The Gain
parameter is the amount of gain pumped into
the preamp, while the Level is the general level
of the effect.
Distortion This one is a digital distortion; very similar to
the Overdrive, but with a less “round” quality.
Compressor Use the compressor to avoid signal peaks (and
thus clipping) or missing notes. Use the Sensi-
tivity parameter to set the minimal threshold
before the Compressor enters. The Attack and
Release parameters set the speed of the Com-
pressor entering or exiting.
Note: If the Input stage is in clipping (red-col-
ored SIGNAL LED), the compressor cannot
avoid clipping. Try to reduce the GAIN level.
Effect Parameter Value
Chorus Speed 0-30
Depth 0-30
Level 0-30
Delay Feedback 0-30
Time 0-30
Level 0-30
Hall, Room Tone 0-10
Time 0-30
Level 0-30
FX1:Chorus FX2:Hall
Speed:10 Tone:10
Depth:15 Time:14
Level:10 Level:10
Gbl:VocalSetup 3
Effect Parameter Value
Tone Low ±15
Middle ±15
High ±15
Overdrive,
Distortion Gain 0-30
Level 0-30
Compressor Sensitivity 0-30
Attack 0-10
Level 0-30
TONE:On DRIVE:OvDrv
High:+10
00 Gain:+10
Low:+10 Level:127
Gbl:Gtr Setup 1