COMe-mAL10 – User Guide, Rev. 1.3
www.kontron.com
// 70
Function
Second level Sub-Screen / Description
SATA Drivers>
(continued)
SATA Port 0>
or
SATA Port 1>
SATA Port #>
Read only field
SATA port installed/Not Installed and
software preserve
Port #>
SATA port #
[Enabled, Disabled]
SATA Port 0 Hot
Plug Capability>
Reports SATA port as being Hot Plug
capable
[Enabled, Disabled]
Configured as
eSATA>
Read only field
Mechanical
Presence
Switch>
Controls reporting if port has a mechanical
presence switch
Note: Requires hardware support.
[Enabled, Disabled]
Spin Up Device>
If enabled for a port, staggered spin-up is
performed and only drives with this option
enabled spin up at boot.
Note: Otherwise, all drives spin up at boot.
[Enabled, Disabled]
SATA Device
Type>
Identifies if SATA port is connected to a
solid-state drive or hard disk drive.
[Hard Disk Drive, Solid State Drive]
SATA Port#
DevSlp>
SATA Port # DevSlp
Note: Board rework needed for LP before
enable. [Enabled, Disabled]
DITO
Configuration>
DITO configuration
[Enabled, Disabled]
DITO Value>
Read only field
DM Value>
Read only field
SCC
Configuration>
SCC SD Card
Support (D27:F0)>
SCC card support
[Enabled, Disabled]
SCC eMMC Support
(D28:F0)>
SCC eMMC Support
[Enabled, Disabled]
eMMC Max Speed>
Selects the eMMC max. speed allowed
[HS400, HS200, DDR50]
USB
Configuration>
XHCI Pre-Boot
Driver>
XHCI pre-boot driver support
[Enabled, Disabled]
xHCI Mode>
Disable- disables XHCI controller function and no USB devices
are detectable or usable during boot and in OS.
Note: Do not disable unless required for debugging purposes.
[Enabled, Disabled]
USB VBUS>
VBus should be ‘ON’ in host mode and ‘OFF’ in OTG device mode
[Off, ON]
