COMe-mAL10 – User Guide, Rev. 1.3
www.kontron.com
// 58
Sub-Screen
Function
Second level Sub-Screen / Description
H/W Monitor>
(continued)
measurement, and does not supply an internal diode on the CPU’s die that can be used
instead of PECI. Reading the DTS based values would harm the system’s real-time behavior
and is therefore not used.
External Fan-
Fan Control>
Sets Fan Control mode for external fan
Disable - stops the fan
Manual – manually set the fan
Auto - hardware monitor controls cooling, similar to ACPI based
‘Active Cooling’, without producing a software load to the system.
[Disable, Manual, Auto]
External Fan–
Fan Pulse>
Displays number of pulse the fan produces during one revolution
(Range: 1-4)
External Fan-
Fan Trip point>
Displays temperature at which fan accelerates.
(Range: 20°C to 80°C)
External Fan-
Trip Point
Speed>
Displays fan speed at trip point in %. Minimum value is 30%
Fan always runs at 100% at (TJmax.-10°C)
External Fan
Reference
Temperature>
Determines temperature source used for automatic fan control
[Module Temperature, CPU Temperature]
Additional Information External Fan
An external fan can be connected to baseboard. The external fan’s control lines are routed
via the COMe connector.
5.0V Standby>
Read only field
Displays standby voltage
Batt Volt. at
COMe pin>
Read only field
Displays battery voltage at COMe pin
Widerange VCC>
Read only field
Displays wide range VCC
Serial Port Console
Redirection>
COM0 Console
Redirection>
Console redirection via COMe module’s COM1
[Enabled, Disabled]
COM1 Console
Redirection>
Console redirection via COMe module’s COM2
[Enabled, Disabled]
COM2 Console
Redirection>
Console redirection via COMe module’s COM3
[Enabled, Disabled]
COM3 Console
Redirection>
Console redirection via COMe module’s COM4
[Enabled, Disabled]
Additional Information COM # Console
If redirection is enabled then the port settings such as Terminal type, Bits per second, Data
bits, Parity etc. can be adjusted here. On-module COM ports do not support flow control.
If the Port is disabled, the COM# port is displayed as a read only field.
Legacy Console
Redirection
settings>
Legacy Serial
Redirection
Port>
Selects a COM port to display redirection of legacy
OS and legacy OPROM messages
[COM0, COM1, COM2, COM3]
Serial Port for
Out-of-Band
Management /
Windows EMS
Console Redir.>
Console redirection
[Enabled, Disabled]
