Konsberg AIS 200, Installation Manual

Page: 49 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Software setup procedure
Zone: Transition zone for the region. This parameter is given in nautical miles, and provides
information about the transition zone of the region in which the AIS should change radio
parameters to the ones specified for the region.
5.2.5.3 Edit current region
This function is used to change the current radio parameters and is similar to Add Region , the
only difference being that by changing these values the default parameters for the current
region are altered and take effect immediately.
Note!
For software setup procedure using optional MKD see
on page 92.
Appendix C - Software
setup using optional MKD
5.3 Configuration through PI_serial/PI_LAN
The PI is an NMEA interface for AIS specific messages. All traffic on the VHF radio link is
output as NMEA messages along with various alarms and status messages. Partial
configuration is done through this interface (ref. ITU-R M.1371 for details [2]).
EXT MKD
P1 P2
MKD PILOT
GPS
POWER
VHF
10 Mb LAN
P2
P1
11
1
PI_RD(B)
SENS3 RD(B)
PI_RD(A)
SENS3 RD(A)
PI_TD(B) SENS3 TD(B)
PI_TD(A) SENS3 TD(A)
PI_C SENS3 C
SENS1_RD(B) SENS2_RD(B)
SENS1_RD(A) SENS2_RD(A)
SENS1_TD(B) SENS2_TD(B)
SENS1_TD(A) SENS2_TD(A)
SENS1_C
SENS2_C
10 20
NC ALM NO
RXA_AUDIO ALM_C
RXB_AUDIO
ALM_NC
RXC_AUDIO
ALM C
Not used LR_C
COM2_RXD COM1_RXD
COM2_TXD COM1_TXD
GND GND
Not used LR_RD(B)
Not used
LR_RD(A)
Not used
LR_TD(B)
Not used
LR_TD(A)
1
13
24 12
39