Konsberg AIS 200, Installation Manual

Page: 45 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Software setup procedure
5. SOFTWARE SETUP PROCEDURE
5.1 Configuration
The AIS 200 system is set up with factory settings during testing. The software setup must be
performed as a part of the AIS 200 installation procedure.
After mechanical installation of the AIS 200 unit, the system needs to be configured..
Configuration of the AIS 200 can be carried out in different ways:
1.
By using the internal Minimum Keyboard Display (MKD) on the front
2. By the presentation interface (PI) located on the rear panel - serial port (P2) or LAN port.
3. By editing directly in the setup file.
Partial setup is available through the MKD and the PI, complete setup is only available
through editing the setup file.
5.2 Configuration through internal MKD
The software setup is performed from sub-menus available from the Main Menu page,
activated by pressing the
VIEW
button. The respective Main Menu pages are shown below.
- MAIN MENU ------------
Alarms and LR
Dynamic data
Settings
▼
SMS
Downperiods
Chn.Management
System
This is the Main Menu page for the AIS 200 with sub-
menus. All settings that need to be changed can be
found in the
Settings sub-menu.
For explanation of buttons, manoeuvring in the menus
and for entering data, refer to the
Kongsberg AIS 200
User Manual [1].
35