Konsberg AIS 200, Installation Manual

Page: 28 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Installation
Performed
by
Description
Crew SP
Ref
page
1. Mount the GPS4 antenna included in the AIS 200 system and the third
party VHF antenna.
x
2. Connect the adapter cable to the GPS4 antenna. x
3. Pull cables from the antennas to the AIS 200 Mobile Unit. x
4. Check the GPS and VHF cables for short circuit between the centre
conductors and shield (ground).
x 27
5. Mount the AIS 200 Mobile Unit - mount the MKD.
x 21
onwards
6. Connect the GPS adapter cable to antenna cable. x
7. Connect the GPS4 antenna and the VHF antenna to the plugs on the
rear of the Mobile Unit (connectors to be mounted by SP).
x 24
8. Connect the MKD unit to the Mobile Unit using the supplied cables. x 24
9. Connect the external main GPS sensor to Sensor port 1, 2 or 3 on the
Mobile Unit.
x
10. Connect the vessel’s main heading sensor to Sensor port 1, 2 or 3 on
the Mobile Unit.
x
11. Provide other interface from external sensors to the Mobile Unit. x
12. Connect the Power to the Mobile Unit. Make sure the power supply is
from the vessel's emergency supply.
x
13. Apply power to the AIS 200 system. x
14. Check that the indication on the LED indicators on the Mobile Unit is
as follows:
GPS LED:
blinks green once each second
TX LED: blinks green and amber, at the most 10
seconds between each blink
MSG LED: blinks green and amber, at the most 10
seconds between each blink
x
15. Perform the software setup procedure. x
18