Kongsberg AIS 200 Installation Manual, rev. 2
Installation
3.6
MKD unit
3.6.1
Mechanical installation
The MKD may be panel or bracket (option) mounted. The optional mounting bracket may be
ordered separately.
The unit should be mounted with special regard to the operator’s need for easy operation.
Avoid mounting the MKD where it is easily exposed to sunlight, as this will shorten the
lifetime of the display. If this is not possible, make sure the units are always covered with a
protective cover when not in use.
3.6.1.1
Panel mounting
Make sure that the mounting location includes space for plug and cable bend. The mounting
surface must be flat and even to within 0.5 mm.
1.
Remove the 4 front panel corners from the MKD.
2.
Drill 4 mounting holes and make a panel cut-out according to dimensional drawing, pages
9 and 10.
3.
Fasten the MKD to the panel with the supplied 19 mm screws.
4.
Apply the front panel corners.
Note!
Do not over-tighten the mounting screws
.
21
Summary of Contents for AIS 200
