Konica Minolta bizhub Press 1250P, User Manual

Page: 191 / 202

7-2 Saddle Stitcher SD-513
Cleaning the conveyance belt of the bundle exit tray 7 7.1
7 Cleaning
7.1 Cleaning the conveyance belt of the bundle exit tray
The conveyance belt of bundle exit tray should be kept clean, otherwise soil marks may be printed. Follow
the procedure below to clean the conveyance belt of bundle exit tray .
In order to maintain optimum print quality, we recommend to clean it every time before using the tray.
If any soil marks are found on the conveyance belt while printing, perform this cleaning procedure immedi-
ately.
1
Open the clamp section upper door .
%
The clamp section upper door cannot be opened while the
saddle stitcher is in the initializing state. Open the clamp
section upper door when the saddle stitcher exits the initial-
izing state.
2
Clean the surface of the two conveyance belts with a soft cloth
dampened slightly with alcohol (cleaner).
3
Move the conveyance belt to clean the whole length of the
conveyance belt .
% Raise the two conveyance belts lightly, then pull them both
leftward at the same time in order to show the hidden parts.
% Clean the conveyance belt using a soft cloth dampened
with alcohol (cleaner).
% Repeat steps 2 and 3 (about three times) to clean the whole
round of the belts.
NOTICE
Do not pull the conveyance belt while the saddle stitcher is in
the idle state. Pulling the belts with force may cause unexpected machine trouble. When pulling the con-
veyance belt, be sure to check that the saddle stitcher exits the idle state, then open the
clamp section
upper door .
NOTICE
Do not raise the conveyance belt higher than necessary. Or, never fail to pull the two belts at the same
time. Otherwise, machine trouble may be caused.