Konica Minolta bizhub Press 1250P, User Manual

Page: 147 / 202

5-18 Saddle Stitcher SD-513
[Saddle Stitcher Adjustment] - [Staple Center Adjustment] 5 5.2
2
Display the Staple Center Position Adjustment Screen of 4 Position Staple (Front 2 positions).
%
In bizhub PRESS 1250/1250P/1052 , press [02 Finisher Adjustment], [08 Saddle Stitcher Adjust-
ment], [01 Staple Center Adjustment], and [02 4 Position Staple (Front 2)] in sequence.
%
In bizhub PRESS C1070/C1070P/C1060/C71hc , press [04 Finisher Adjustment], [04 Saddle
Stitcher Adjustment], [01 Staple Center Position], and [02 4 Position Staple (Front 2)] in sequence.
%
In bizhub PRESS C1100/C1085 , press [03 Finisher Adjustment], [04 Saddle Stitcher Adjustment],
[01 Staple Center Position], and [02 4 Position Staple (Front 2)] in sequence.
3
Select the size to be adjusted.
4
Press [Print Mode].
5
Load the paper size selected in step 3 into the tray, then select that tray key.
6
Press Start on the control panel . A sample pattern will be output.
7
Measure the distance from the edge to the center of the front 2 positions of 4 Position Staple relative
to paper size.
8
Exit the print mode to return to the Staple Center Position Adjustment Screen.
% In bizhub PRESS 1250/1250P/1052 , press [Close].
%
In bizhub PRESS C1070/C1070P/C1060/C71hc or bizhub PRESS C1100/C1085 , press [Exit
PrintMode].
9
If adjustment is required, use the touch panel keypad or control panel keypad to enter the setting data.
% Adjustable range: -100 (To move rearward) to +100 (To move frontward) (1 step = 0.1 mm)
%
Use [+<->-] to specify the value to be positive or negative.
% Available range of the adjustment may vary depending on paper sizes.
10
Press [Set] to change the current data.
11
Repeat the steps from 4 to 10 until the desired result is obtained.
12
Press [Return] to restore the Staple Center Position Adjustment Menu Screen.