Konica Minolta bizhub Press 1250P, User Manual

Page: 105 / 202

4-68 Saddle Stitcher SD-513
Combining Perfect Binder PB-503 4 4.13
4.13 Combining Perfect Binder PB-503
The machine with Perfect Binder PB-503 installed automatically attaches a printed set with a cover to make
a perfect-bound book, applying a dab of glue to the spine.
If Saddle Stitcher SD-513 is combined, the following functions are available.
- Cover Fore-edge Trim
- If [ON] is selected, the machine trims the cover by the amount automatically estimated from the follow-
ing formula, in the range from 5 mm to 40 mm in 0.1 mm increments.
Trimming width = (Cover width) - (Body width
e
2) - (Spine width)
- If the estimated amount exceeds 10 mm, the machine will automatically trim the cover whether this
function is activated or not.
- Cover 2-Side Slit
- This function is available when using Trimmer Unit TU-503 equipped in Saddle Stitcher SD-513 .
- Perform 2-side slitting on the head and the foot of cover loaded in a tray other than the cover tray of a
perfect binder. 2-side slitting cannot be performed for body.
- Slitting can be specified within the range from 8.0 mm to 26.0 mm in increments of 0.1 mm.
- The difference of specified 2-side slitting between the head and the foot must be within 10.0 mm.
- Crease
- This function is available when using Creaser Unit CR-101 equipped in Saddle Stitcher SD-513 .
- Selecting [(3)Spine] will add 2 creases on the fold part of the spine.
- Selecting [(4)Gutter] will add 2 creases on the gutter of the front cover and the back cover, making
bound pages easier to flip. The crease side is fixed to [Back].
- Selecting [(3) Spine + (4) Gutter] will add 2 creases each on the back cover and the gutter.
4.13.1 Making Perfect-Bound Booklets
d
Reference
See the User's Guide supplied with this machine for details on how to normally use perfect-bound booklets.
1
On the Copy screen, specify the tray with body paper loaded, then press [Output Setting] and [Perfect
Bind] in sequence.
The Perfect Bind Screen will be displayed.
The heater of the perfect binder automatically starts warming up. The warmup takes approximately 20
minutes.
NOTICE
Perfect Binder PB-503 will not stop warming up even if [Default Set] is pressed on the Output Setting
Screen or Reset is pressed on the Control panel .
To stop using Perfect Binder PB-503 , return to the Machine Screen, then press [OFF] of PB heater
switch. When you stop using the perfect binder, be sure to turn off the heater so as to prevent the deg-
radation of glue pellets.