Konica Minolta bizhub Press 1250P, User Manual

Page: 107 / 202

4-70 Saddle Stitcher SD-513
Combining Perfect Binder PB-503 4 4.13
4
Select the settings for cover print, cover print side, and bind direction.
% Cover Print can be set to [ON] when one of [Tray1] to [Tray11] is specified as the cover tray. By se-
lecting [ON], Cover Print Side becomes selectable.
% The cover print operations will differ, depending on whether the number of original sheets is odd or
even.
% When using Creaser Unit CR-101 or Trimmer Unit TU-503 equipped in Saddle Stitcher SD-513 ,
[Previous] and [Next] display at the lower left corner of the screen. Cover trim can be specified in
"(1)Cover Fore-edge Trim" and "(2)Cover 2-Side Slit" displayed when [Next] is pressed. See steps
7 to 10 for details.
5
Specify the spine width.
% Press [Change Set] on the right side of [Spine Width (1-30 mm)] to display the Spine Width Screen.
Use the touch panel keypad, [
,
], [
+
], or the control panel keypad to enter the desired value.
% This setting is effective with Cover Print set to [ON].
%
Press [OK] to restore the Perfect Bind Screen.
6
Make fine adjustments in the lead edge, trimming width, and image position of the cover.
%
In bizhub PRESS 1250/1250P/1052 , press [Change Set] on the right of [Fine Adjustment] to display
the Fine Adjustment window, then make adjustments.
%
In bizhub PRESS C1070/C1070P/C1060/C71hc or bizhub PRESS C1100/C1085 , press [Change
Set] on the right of [Cover Fine Adj.] to display the Fine Adjustment window, then make adjustments.
Press [OK] to restore the Perfect Bind Screen.
7
Press [Next].
The Perfect Bind Screen will display for specifying a trimming mode (fore-edge trimming or 2-side slit-
ting) or crease.