Konica Minolta bizhub Press 1250P, User Manual

Page: 174 / 202

Saddle Stitcher SD-513 5-45
5.12 [Saddle Stitcher Adjustment] - [Crease Position Adjustment] 5
2
Display the Tri-Fold Crease Position Adjustment Screen.
%
In bizhub PRESS 1250/1250P/1052 , press [02 Finisher Adjustment], [08 Saddle Stitcher Adjust-
ment], [11 Crease Position Adjustment], and [02 Tri-Fold Crease Position] in sequence.
%
In bizhub PRESS C1070/C1070P/C1060/C71hc , press [04 Finisher Adjustment], [04 Saddle
Stitcher Adjustment], [11 Crease Position Adjustment], and [02 Tri-Fold Crease Position] in se-
quence.
% In bizhub PRESS C1100/C1085 , press [03 Finisher Adjustment], [04 Saddle Stitcher Adjustment],
[11 Crease Position Adjustment], and [02 Tri-Fold Crease Position] in sequence.
3
Select the size to be adjusted.
4
Press [Print Mode].
5
Load the paper size selected in step 3 into the tray, then select that tray key.
6
Press Start on the control panel . A sample pattern will be output.
7
Check the misalignment (a) between the fold and crease of the output sheet.
Allowance: a = within ^ 1 mm
8
Exit the print mode to return to the Tri-Fold Crease Position Adjustment Screen.
% In bizhub PRESS 1250/1250P/1052 , press [Close].
%
In bizhub PRESS C1070/C1070P/C1060/C71hc or bizhub PRESS C1100/C1085 , press [Exit
PrintMode].
9
If adjustment is required, select [1st Fold] or [2nd Fold] and use the touch panel keypad or control pan-
el keypad to enter the setting data.
% Adjustable range: -20 (To shorten) to +20 (To lengthen) (1 step = 0.1 mm)
%
Use [+<->-] to specify the value to be positive or negative.
% Adjust the distance between the inside edge and the 1st or 2nd fold crease.
10
Press [Set] to change the current data.
11
Repeat the steps from 4 to 10 until the desired result is obtained.
12
Press [Return] to restore the Crease Position Adjustment Menu Screen.
[1] Fold [2] Edge of crease