Problem
Main causes
Remedy
Pinion of starting motor repeats en-
gaging and disengaging (rattles).
Insufficient battery charge
Charge battery.
Defective safety relay
Replace. (*)
Starting motor turns engine sluggish-
ly.
Insufficient battery charge
Charge battery.
Defective starting motor
Replace. (*)
Starting motor disengages before
engine starts.
Defective wiring, defective ring gear
and pinion
Check, repair. (*)
Insufficient battery charge
Charge battery.
Preheating pilot lamp does not light
up.
Defective wiring
Check, repair. (*)
Defective heater relay
Replace. (*)
Defective monitor
Replace. (*)
Oil pressure caution lamp does not
light up when engine is stopped
(starting switch is at ON position).
Defective monitor
Replace. (*)
Defective oil pressure caution switch
Replace. (*)
When startability at low temperature
is poor, if you touch the outside of
the electric heater by hand after pre-
heating, it is not felt warm.
Defective wiring
Check, repair. (*)
Wire breakage in electrical intake air
heater
Replace. (*)
Defective operation of heater relay
Replace. (*)
Blown fuse of the heater
Replace. (*)
Engine does not start.
(“L04” lights up on monitor.)
Damaged data in the controller
Check, repair. (*)
Other system troubles
Check, repair. (*)
PHENOMENA AND ACTIONS FOR CHASSIS
• Contact your Komatsu distributor for the remedies indicated with (*) in the remedy column.
• Ask your Komatsu distributor for repairs for problems or causes which are not listed below.
Problem
Main causes
Remedy
Speed of travel, swing, boom, arm,
bucket is slow
Lack of hydraulic oil
Make the oil level to the specified lev-
el by referring to CHECKS BEFORE
STARTING.
Pump generates unusual noise.
Clogged element in hydraulic tank
strainer
Looseness of the suction hose
Lack of hydraulic oil
Clean. See EVERY 2000 HOURS
MAINTENANCE.
Retighten.
Make the oil level to the specified lev-
el.
Excessive rise in hydraulic oil temper-
ature
Dirty oil cooler
Clean. See EVERY 500 HOURS
MAINTENANCE.
Lack of hydraulic oil
Make the oil level to the specified lev-
el by referring to CHECKS BEFORE
STARTING.
Track comes off.
Track too loose
Adjust track tension. See WHEN RE-
QUIRED.
Abnormal wear of sprocket
Bucket rises slowly or does not rise at
all.
Lack of hydraulic oil
Make the oil level to the specified lev-
el by referring to CHECKS BEFORE
STARTING.
TROUBLES AND ACTIONS
OPERATION
3-246
Summary of Contents for PC700LC-11
