1.
Open the cover on the left side of the machine, and check
it with the dipstick (G).
2.
The oil level should be between the (H) and (L) marks on
the dipstick (G).
If the oil level is below the mark L, add oil through the dip-
stick pipe hole.
METHOD FOR CHECKING COOLANT LEVEL, ADDING COOLANT
k
k
WARNING
• Do not open the radiator cap unless it is necessary. When checking the coolant level, check it with
the reservoir tank when the engine is cold.
• Immediately after the engine is stopped, the coolant is still hot and the pressure is accumulated in
the radiator. You may get burn injury if you remove the cap in this state. Always wait for the temper-
ature to go down, turn the cap slowly to release the pressure, then remove the cap with care.
1.
Open the engine hood.
NOTICE
If the reservoir tank is empty, leakage of coolant
should be suspected. After checking, repair any ab-
normality immediately.
REMARK
If the inside of reservoir tank (1) is so dirty that you cannot
check the coolant level, see “METHOD FOR USING
FUEL, COOLANT AND LUBRICANTS ACCORDING TO
AMBIENT TEMPERATURE”.
2.
Check the reservoir tank (1).
If the coolant level is within the range between FULL and
LOW, the coolant amount is at a proper level.
If the coolant level is below LOW, add coolant to FULL lev-
el through the filler port of reservoir tank (1).
3.
Tighten the cap securely after adding.
4.
Check the coolant level in the radiator. If the coolant level
is low, add Non-Amine Engine Coolant (AF-NAC) of the
same density to the radiator, and then add it to the reser-
voir tank.
OPERATION
MACHINE OPERATIONS AND CONTROLS
3-143
Summary of Contents for PC700LC-11
