95
Configuration
Sensor Verification (TAG, GROUP)
When Memosens sensors are calibrated in the lab, it is often useful and sometimes
even mandatory that these sensors will be operated again at the same measuring
points or at a defined group of measuring points. To ensure this, you can save the
respective measuring point (TAG) or group of measuring points (GROUP) in the
sensor. TAG and GROUP can be specified by the calibration tool or automatically
entered by the transmitter. When connecting an MS sensor to the transmitter, it can
be checked if the sensor contains the correct TAG or belongs to the correct GROUP.
If not, a message will be generated, Sensoface gets “sad”, and the display backlight-
ing turns purple (magenta). The “sad” Sensoface icon can also be signaled by a
22 mA error current. Sensor verification can be switched on in the Configuration in
two steps as TAG and GROUP if required.
When no measuring point or group of measuring points is saved in the sensor, e.g.,
when using a new sensor, Stratos enters its own TAG and GROUP. When sensor veri-
fication is switched off, Stratos always enters its own measuring point and group.
A possibly existing TAG/GROUP will be overwritten.
Menu item
Action
Choices
Measuring point
(TAG)
In the lower display line you can
enter a designation for the measuring
point (TAG) and for a group of mea-
suring points (GROUP) if applicable.
Up to 32 digits are possible.
Select character using
keys,
select next digit using
keys.
Press
enter
to confirm.
By pressing
meas
(repeatedly) in the
measuring mode you can view the
tag number.
A...Z, 0...9, – +
< > ? / @
The first 10
characters are
seen in the
display with-
out scrolling.
Switch Off the Display Backlighting
The display backlighting can be switched off in the DISPLAY menu.
Note:
If the display backlighting is off, color signaling of error events is not possible.
Summary of Contents for Stratos Pro A201 PH
Page 174: ...174 Index ...
Page 175: ...175 ...
