40
5.4.2
Auto Standby
If the Auto Standby mode is activated, Klick & Show will automatically switch to power saving mode, a selectable
time after the last Sensor-button TOUCH was plugged off, or WiFi of a mobile unit was disconnected, there is no
active signal at external HDMI-input, or there is no operation at the system. Time is selectable from Never to 30
minutes. In Standby green LED (2) in window of front of Base-unit is flashing and HDMI-output is switched off.
When a Sensor-button TOUCH is plugged in and connected, or a mobile unit is connected, or an active
signal is at external HDMI-input, Standby is deactivated.
Pressing of Power-button or movement of mouse at USB-input at Base-unit deactivates Standby mode also.
5.4.3
AirPlay screen quality
Click to select the image quality when transmit apple device by “AirPlay” mode, including
High:
1920x1080
Medium: 1280x720
Low:
1136x640.
Note:
Different AirPlay quality will occupy different data rate. Under a certain data rage, lower resolution will get better
frame rate.
5.4.4
HDMI output resolution
Select the resolution at HDMI output of base-unit. When the new resolution can not be displayed, the previous
resolution is displayed after approx. 15 seconds. System will reboot to make changes.
Existing HDMI output resolution:
3840x2160 @60Hz
3840x2160 @30Hz (nur
K-10S)
Auto (nur
K-10S)
1920x1200 @60Hz
1920x1080 @60Hz (
K-10S / K-10L Lite)
In AUTO-mode Klick & Show automatically switch the output-resolution to the monitor preferred resolution
(EDID), when the base-unit is booting (Power-key). (One of these four available output resolutions).
Summary of Contents for Klick & Show K-10S
Page 79: ...79 9 1 Dimensions...
