69
7.2
Upgrading Firmware Base-unit
Download the actual firmware from
https://www.klickandshow.com/
.
1.
You need to unzip the file “update.bin” first and copy the updating file to the root directory of the USB
drive.
2.
Connect the USB drive to either USB port of Base-unit.
Note: each port can handle max. load of 500 mA.
Klick & Show recognizes the “update.bin”-file at a plugged-in USB stick automatically and starts the “Full
update” procedure.
You can plug out the USB stick within 10 seconds to stop the update.
Attention !!
Do not disconnect power during upgrading progress. Or, the unit firmware will be corrupted.
The upgrading progress displays as shown below, and the unit will reboot automatically after complete the
updating 100%, as shown below.
Note:
During the update, screen can be temporary dark.
If the progress bar stops at 1%, use another USB stick, it may be defective.
The display device shows the Home Screen after normal boot of the device, you can disconnect USB-drive.
Summary of Contents for Klick & Show K-10S
Page 79: ...79 9 1 Dimensions...
