70
3.
Perform “Factory Reset”when the firmware update is complete?
Only when the associated “Release notes” are requiring an additional „Factory Reset“, perform it via the
menu „System Update“ / „Factory Reset”.
All data of configuration will be lost
. So that you do not have to re-configure all data in an elaborate
process, therefore note all settings within the Sub-menus before doing Factory Reset.
4.
The update of Base-unit is finished.
7.3
Upgrading and Pairing of Sensor-button TOUCH
1.
Plug the to be updated Sensor-button TOUCH to either of the two USB port of Base-unit. It will
automatically show up a message to indicate if the installed firmware of Sensor-button is older, and needs
to be upgraded.
The upgrading progress starts automatically with the progress bar, as shown below.
2.
“Pairing” to the Base-unit is done automatically afterwards.
When you get the message:
You can plug out the Sensor-button TOUCH. Update all other Sensor-buttons accordingly.
Summary of Contents for Klick & Show K-10S
Page 79: ...79 9 1 Dimensions...
