Kikusui PWX750ML, User Manual

Page: 9 / 110

PWX
9
No.
Name Function
1 POWER switch
Flip the switch to the ( ) side to turn the power on. Flip it to the ( ) side to turn the
power off.
p.13
2
CURRENT knob Used to set the current value or select a parameter number in the CONFIG settings. p.25, p.36
FINE Used to make fine current value adjustments. p.25
3
VOLTAGE knob Used to set the voltage value or change the value of a CONFIG parameter. p.25, p.36
FINE Used to make fine voltage value adjustments. p.25
4 Air inlet (louver) Air inlet for cooling the inside of the PWX750ML. –
5 OUTPUT key Used to turn output on and off. p.26
6
SET key Used to set and confirm the output voltage and output current (the key has an LED). p.24
ALM CLR key Used to release protection functions that have been activated (the key has an LED). p.31
7
OCP
•
OVP keys
Used to set and display the overcurrent protection (OCP), overvoltage protection
(OVP), undervoltage limit (UVL) trip points (the key has an LED).
p.32
A Used to recall and save the value of preset memory A (the key has an LED). p.47
8
CONFIG key Used to configure the various operating conditions (the key has an LED). p.36
B Used to recall and save the value of preset memory B (the key has an LED). p.47
9
PWR DSPL key Used to display the output power on the ammeter (the key has an LED). p.24
C Used to recall and save the value of preset memory C (the key has an LED). p.47
10
LOCAL key Used to switch between local mode and remote mode (the key has an LED). p.50
LOCK key
Used to lock the operation of all keys other than the OUTPUT key (the key has an
LED).
p.49
11 SHIFT key Used to enable the functions that are written in blue characters below the key. –
12 Ammeter Displays the current, power, or the parameter number of a CONFIG parameter. p.24, p.36
13 CC LED Lights in red during constant current mode. p.29
14 Voltmeter Displays the voltage, the value of a CONFIG parameter, or the cause of an alarm.
p.24, p.30,
p.36
15 CV LED Lights in green during constant voltage mode. p.29
16 OUTPUT LED
Lights in green when output is turned on. Blinks orange when output is on and a pro-
tection function has been activated.
p.26, p.30
17 ALARM LED
Lights in red when a protection function has been activated, However, does not light
when a undervoltage limit (UVL) protection has been activated, Blinks red when the
power limit (POWER LIMIT) has been activated.
p.30
18 PRESET LED
A: Lights in green when the memory A values are being recalled or saved.
B: Lights in green when the memory B values are being recalled or saved.
C: Lights in green when the memory C values are being recalled or saved.
p.47
19 LOCK LED Lights in green when the keys are locked. p.49
20 REMOTE LED Lights in green during remote control. –
21 LAN LED
Lights and blinks when the LAN interface is in use.
• No fault status: Lights in green.
• Fault status: Lights in red.
• Standby status: Lights in orange.
• WEB identify status: Blinks green.
–
See