Kikusui PWX750ML, User Manual

Page: 12 / 110

12
PWX
Connecting the Power Cord
This product is a piece of equipment that conforms to IEC Overvoltage Category II (equip-
ment that consumes energy supplied from a fixed installation).
1
Check that the AC power line meets the nominal input rating of the prod-
uct.
The product can receive a nominal line voltage in the range of 100 Vac to 240 Vac at
50 Hz or 60 Hz.
2
Check that the POWER switch is turned off.
3
Connect the power cord to the AC inlet on the rear panel.
4
Insert the power plug into a grounded outlet.
WARNING
Risk of electric shock.
• This product is a piece of equipment that conforms to IEC Safety Class I (equipment
that has a protective conductor terminal). Be sure to earth ground the product to
prevent electric shock.
• The product is grounded through the power cord ground wire. Connect the protec-
tive conductor terminal to earth ground.
• Use the supplied power cord to connect to the AC line. If the supplied power cord cannot
be used because the rated voltage or the plug shape is incompatible, have a qualified engi-
neer replace it with an appropriate power cord that is 3 m or less in length. If obtaining a
power cord is difficult, contact your Kikusui agent or distributor.
• The power cord with a plug can be used to disconnect the PWX750ML from the AC power
line in an emergency. Connect the plug to an easily accessible power outlet so that the plug
can be removed from the outlet at any time. Be sure to provide adequate clearance around
the power outlet.
• Do not use the supplied power cord for other devices.