Kikusui PWX750ML, User Manual

Page: 51 / 110

PWX
51
2
Basic Functions
Factory Default Settings (Initialization)
If you hold down SHIFT+LOCAL while you turn the POWER switch on, the PWX750ML will
be reset to the factory default settings.
The factory default settings are shown below.

Basic settings

CONFIG settings
Basic item Parameter description
Output voltage 0 V
Output current 105 % of the rated output current
OVP (overvoltage protection) 112 % of the rated output voltage
OCP (overcurrent protection) 112 % of the rated output current
UVL (undervoltage limit) 0 V
Param.
number
CONFIG parameter Parameter description
CF01 Master-slave parallel operation parameter 1 (independent operation)
CF02
1 Power-on status parameter SAFE (panel settings that were in use the
last time the power was turned off)
CF03 Method for clearing OHP, FAN, and AC-FAIL alarms SAFE (do not clear the alarm automatically)
CF04
1 Memory content display parameter ON (displayed)
CF05
1
CC control using an Vext or Rext OFF
CF06
1 CV control using an Vext or Rext OFF
CF07
1 CV/CC control range parameter LO (0 V to 5 V)
CF08 Range during voltage and current monitoring LO (0 V to 5 V)
CF09
1 External control parameter for turning output on and off OFF
CF10
1 External control logic parameter for turning output on
and off
LO (a LOW signal turns output on)
2
CF11 Bleeder on/off parameter ON (bleeder circuit is on)
CF12
1 Output-on startup state parameter CV (CV is prioritized)
CF13 Detection time of OCP activation 0 ms
CF14
1 Current setting limit ON (the setting is limited)
CF15
1 Voltage setting limit ON (the setting is limited)
CF16 Panel display brightness setting 7
CF17 Communication monitor timer setting OFF (Communication monitoring timer off)
CF20 Remote interface parameter LAN
CF21 Command language parameter SCPI
CF22 Emulation parameter during remote control NONE (PWX series commands)
CF23 SCPI communication error display parameter OFF (not displayed)
CF24 Multichannel (VMCB) domain number 0 (the multichannel function is not used)
CF25 Multichannel (VMCB) channel number 0 (the PWX is used as a master unit on the
multichannel network)
CF30 DHCP parameter ON (a server is used)
CF31 AUTO IP address parameter ON (the AUTO IP function is used)
CF32 MANUAL IP address parameter OFF (the MANUAL IP address function is
not used)
CF42 SCPI-RAW protocol TCP port number 5025
CF60 RS232C baud rate parameter 19.2 (kbit/s)
1 You can only specify this parameter when the PWX series is being used as a master unit.
2 0 V to 0.5 V or shorted.