Kikusui PWX750ML, User Manual

Page: 14 / 110

14
PWX
Rack Mounting
Turning the POWER switch Off
Flip the POWER switch to the ( ) side to turn the PWX750ML off.
The PWX750ML saves the panel settings (except the output on/off setting) that were in use
immediately before the POWER switch was turned off.
p.39
You can use the CONFIG settings (CF02) to select how the PWX750ML starts when the
POWER switch is turned on.
If the POWER switch is turned off immediately after the settings have been changed, the last
settings may not be stored.
Rack Mounting
p.100
You can mount one or two PWX750MLs side by side to a rack. You can use brackets or slide
rails to mount the PWX750ML to a rack.
Remove the rubber feet before you mount the PWX750ML to a rack.
If you are mounting two PWX750MLs side by side, install the optional support board to sup-
port the two PWX750MLs.
Attach the optional support angles (KRB1-PWX SUPPORT ANGLE) to support the
PWX750ML.
We recommend that you keep all pieces that you have removed from the PWX750ML. You
will need these pieces if you remove the PWX750ML from the rack.
If you remove the PWX750ML from the rack, re-attach the original rubber feet.
When using several PWX750ML power supplies together, such as for master-slave parallel
operation or series operation, mount them to a rack before use.
You can mount the PWX750ML to the Kikusui KRC series and KRO series racks.
Removing the rubber feet
Loosen the screws to remove the rubber feet (in four locations).
See
CAUTION
After you turn the POWER switch off, wait at least 10 seconds after the panel display turns
off before you turn the POWER switch back on. Repeatedly turning the POWER switch on
and off at short intervals can cause damage to the inrush current limiter. Furthermore, this
will shorten the service life of the POWER switch and the internal input fuse.
See
Rubber foot
Screw (4 locations)
M3 screw
Max. depth: 8 mm [0.31 inches]
(
)