Kikusui PWX750ML, User Manual

Page: 36 / 110

36
PWX
CONFIG Settings
Use the CONFIG settings to set the PWX750ML system configuration. You can set and dis-
play the following parameters in the CONFIG settings. The CONFIG parameters are listed in
a separate document (included with this manual).
Effects:
●
indicates a parameter that may be affected when the panel settings are reset (CF00) or when a
preset memory entry is loaded.
▼
indicates a parameter that may be affected when the master unit, the slave unit, or the number
of units is changed (CF01).
In the “Note” column, “A” indicates a parameter that is applied immediately, “B” indicates a parameter
that is applied when the PWX series is turned on, and “C” indicates a parameter that is applied when
CF34 is executed.
Display
switching Parameter
number
Setting or display description Effect Note
SYSTEM
CF00
1
1 You can only specify this parameter when the PWX series is being used as a master unit.
Resets the panel settings — A
CF01 Master-slave parallel operation parameter
▼
B
CF02
1 Power-on status parameter — B
CF03 Method for clearing OHP, FAN, and AC-FAIL alarms — B
CF04
1 Memory content display parameter — A
CF05
1 CC control using an Vext or Rext
●
A
CF06
1 CV control using an Vext or Rext
●
A
CF07
1 CV/CC control range parameter — A
CF08 Range during voltage and current monitoring — A
CF09
1 External control parameter for turning output on and off
●
▼
A
CF10
1 External control logic parameter for turning output on and off
▼
A
CF11 Bleeder on/off parameter — A
CF12
1 Output-on startup state parameter
▼
A
CF13 Detection time of OCP activation — A
CF14
1 Current setting limit
●
▼ A
CF15
1 Voltage setting limit
●
▼ A
CF16 Panel display brightness setting — A
CF17 Communication monitor timer setting — A
INTERFACE CF20 Remote interface parameter
▼
B
CF21 Command language parameter
▼
B
CF22 Emulation parameter during remote control
▼
B
CF23 SCPI communication error display parameter
▼
A
CF24 Multichannel (VMCB) domain number parameter
▼
B
CF25 Multichannel (VMCB) channel number
▼
B
LAN CF30 DHCP parameter
▼
B or C
CF31 AUTO IP address parameter
▼
B or C
CF32 MANUAL IP address parameter
▼
B or C
CF33 Resets the LAN interface settings (LCI)
▼
A
CF34 Restarts the LAN interface (REBOOT)
▼
A
CF35 IP address display (1)
▼ ─
CF36 IP address display (2)
▼ ─
CF37 IP address display (3)
▼ ─
CF38 IP address display (4)
▼ ─
CF39 MAC address display (1) and (2)
▼ ─
CF40 MAC address display (3) and (4)
▼
─
CF41 MAC address display (5) and (6)
▼
─
CF42 SCPI-RAW protocol TCP port number
▼
B or C
USB CF50 VID (vendor ID) display
▼
─
CF51 PID (product ID) display
▼
─
RS232C CF60 RS232C baud rate parameter
▼
B
Parameter number,
CF (CONFIG)
+ a two-digit number
Setting display
Lit
CONFIG setting and
display examples