KEP MMI-1500, Installation & Operation Manual

Page: 218 / 306

210
16.3.3.2 Wiring for cable connections using
PLC5 CPU’s
with RS422 D-Sub 25 Male Socket ports.
KEP Part#: (Not Available) (D-Sub 9 Female Plug to D-Sub 25 Female Plug Cable)
HMI PLC[RS-485] Connect to AB PLC5 CPU’s with RS422 Port
2 RxD+ Æ 14 TxD+
1 RxD- Æ 2 TxD-
4 TxD+ Æ 16 RxD+
3 TxD- Æ 3 RxD-
5 GND 7 GND
4 RTS+
Æ 5 CTS+
6 DSR+
Æ
8 DCD+
Æ
20 DTR+
22 DSR- Æ 10 DCD- Æ 23 DTR-
19 RTS- Æ 13 CTS-
Shield Æ Earth Ground
Note:
Graphic representation may not reflect the actual appearance of the finished cable.
16.3.4 Device address
Bit/Word Type Address
Format
Range Notes
B I1 dddbb ddd: 000~254 bb: 00~15 See Note 16.2.5 after this section
B O0 dddbb ddd: 000~254 bb: 00~15 See Note 16.2.5 after this section
B B3, 10~13 dddbb ddd: 000~254 bb: 00~15 File number is fixed, specify both Element and Bit
W N7, 10~15 ddd ddd: 000~254 File number is fixed, specify Element
W Nfn* fffddd fff: 7, 10~254 ddd: 000~254 Both File and Element must be specified
W F8 (N8) ddd ddd: 000~255 Floating Point words
W Ffn* fffddd fff: 7, 10~254 ddd: 000~254 Both File and Element must be specified
W F8 (N8) ddd ddd: 000~254 Floating Point words
W T4 SV,PV ddd ddd: 000~254 PV is timer accumulator, SV is preset
W C5 SV,PV ddd ddd: 000~254 PV is counter accumulator, SV is preset
Note:
Attempting to access a device that is not defined in PLC memory causes the
HMI to display the “No response” error message.
Note:
The PLC’s memory range may vary within the range supported by the driver. Use appropriate addresses.
Note:
See Note 16.3.5 for more information on formatting Device Addresses.
Note: *
Nfn and Ffn device types allow access to any data file (fff) and element (nnn) in memory. fff specifies the data file
000-254, and nnn specifies the element number 000-254. For example, to specify Integer data file 15, element 7 (N15:7),
select Nfn as the device type and enter 015007 as the Device address.
See Note 16.3.5 for more information on formatting Device Addresses.