Kemper Champion C 1200, Operating Manual

Page: 18 / 59

19 Technical instructions C 1200
Steering capability Sufficient steering capability is only ensured if at least 20 % of the total
weights are acting onto the tractor front axle.
Hitch
The hitch is not designed for supporting any additional load. Please
also observe the corresponding decal placed on the machine.
NOTE:
1. It is not permissible to hitch a two-wheeled trailer to a rear
mounted machine.
2. A four-wheel trailer may be attached if the following conditions
are fulfilled:
a) Maximum forward speed: 25 km/h
b) The trailer is fitted with an overrunning brake or with a
brake system which can be operated by the tractor driver
c) The permissible total weight of the trailer is not superior
to the permissible total weight of the tractor x 1.25, but at
most 5 tons.
Overload protection in the
spur gear drive of the
precompression rollers
(Fig. 30) The friction clutch of the PTO drive shaft protects the drive system and
flywheel against overload. Any overload in the feed mechanism will
activate the pin type safety clutch fitted to the spur gear lubricated with
rolling bearing grease Gresalit LZ 2.
The torque of the clutch is preset. The housing is welded so that the
clutch cannot get loose and the torque settings cannot be modified.
Should it nevertheless be necessary to remove the clutch you should
note that the cup springs 180 are pre-tensioned and circlip 120 can only
be removed if this tension is released.