Keithley TEC SourceMeter 2510, User Manual

Page: 241 / 244

SCPI Commands
DISPlay subsystem 10-3, 10-14
FORMat subsystem 10-4, 10-19
OUTPut subsystem 10-4, 10-25
SENSe[1] subsystem 10-5, 10-26
SOURce[1] subsystem 10-7, 10-34
SOURce2 subsystem 10-11, 10-45
STATus subsystem 10-12, 10-46
SYSTem subsystem 10-13, 10-48
Trigger subsystem 10-13, 10-54
UNIT subsystem 10-14, 10-54
SCPI reference tables 10-2
SCPI signal-oriented measurement
commands 9-1
SDC (selective device clear) 6-12
Selecting an interface 6-2
SENSe1 subsystem 10-26
Current function 10-26
Resistance function 10-27
Temperature function 10-28
Sensing
2-wire 2-5
4-wire 2-6
Considerations 2-5
INPUT 2-5
OUTPUT 2-5
Sensor coefficients 4-14
RTD coefficients 4-14
Thermistor coefficients 4-14
Serial number identification 1-9
Serial polling and SRQ 7-9
Setpoint tolerance 3-15
Configuration 3-8
Indicator 3-16
Menus 1-26
Operation 3-17
Setting
Interface parameters 6-2
Settings 1-16
Factory defaults 1-16
Line frequency 1-9
Saving and restoring user setups 1-16
Solid-state sensor restrictions 3-18
SOURce[1] subsystem 10-34
Control source output-off 10-34
Current function 10-35
Resistance function 10-36
Select source function 10-34
Setpoint tolerance 10-42
Temperature function 10-38
Voltage function 10-41
SOURce2 subsystem 10-45
SPE, SPD (serial polling) 6-12, 7-9
Specifications A-1
Status and error messages 1-15, B-2
Status byte and service request commands 7-10
Status byte and SRQ 7-2, 7-7
Status byte register 7-8
Status register
16-bit 7-5
Status register sets 7-2, 7-11
Status register structure 7-3
Status structure 7-1
STATus subsystem 10-46
Error queue 10-47
Program event enable registers 10-46
Read condition registers 10-47
Read event registers 10-46
Select default conditions 10-47
Syntax 6-12
System identification 1-9
SYSTem subsystem 10-48
2-wire/4-wire sense mode 10-52
Default conditions 10-48
Error queue 10-50
Ground connect mode 10-53
Read version of SCPI standard 10-52
Reset timestamp 10-52
RS-232 interface 10-53
Select power line frequency setting 10-49
Simulate key presses 10-51
T
TEC control algorithms
Proportional (P) 4-3
Proportional-derivative 4-4
Proportional-integral-derivative 4-4