1-16
Getting Started
Models 2510 and 2510-AT User’s Manual
Default settings
By using appropriate menu selections, you can save and recall various instrument setups,
define the power-on configuration, or restore factory defaults as outlined below.
Saving and restoring user setups
You can save and restore five of your own user setups as covered below. This feature pro-
vides a convenient way to save specific instrument configurations and then recall them as
needed. Note that you can also set up the Model 2510 to restore a specific user setup at
power-on (see
“Power-on configuration,” page 1-16
using *SAV and *RCL to perform these operations by remote.
Saving setups
1.
Select the various instrument operating modes you wish to save.
2.
Press the MENU key, select SAVESETUP, then press ENTER.
3.
Select SAVE, then press ENTER.
4.
Select the setup position (0 to 4) to save, then press ENTER to complete the
process.
Restoring setups
1.
Press the MENU key, select SAVESETUP, then press ENTER.
2.
Select RESTORE, then press ENTER.
3.
Select the setup position (0 to 4) to restore, then press ENTER to complete the
process.
Power-on configuration
You can also define which of the stored setups (factory default or user) the instrument
assumes as the power-on configuration as follows:
1.
Press the MENU key, select SAVESETUP, then press ENTER.
2.
Select POWERON, then press ENTER.
3.
From the SET POWER-ON DEFAULT menu, choose the power-on configuration:
BENCH or GPIB (see below), or USER-SETUP-NUMBER.
4.
If you chose to use a user setup as the power-on configuration, select the user setup
number, then press ENTER.
Factory default settings
There are two sets of factory defaults, BENCH (front panel) and GPIB (remote). For front
panel operation, BENCH and GPIB defaults are the same and are summarized in
. You can restore these default conditions as follows:
1.
Press the MENU key, select SAVESETUP, then press ENTER.
2.
Select RESET, then press ENTER.
3.
Select BENCH or GPIB defaults, then press ENTER to complete the process.
See the SCPI reference tables in
for remote default information.
Summary of Contents for TEC SourceMeter 2510
