CAUTION
Damage from changing the handpiece and angle piece during operation.
Wear to the catch on the handpiece and angle piece and the motor
Unbalanced motor axis.
▶ Change the handpiece and angle piece only when the motor not running.
CAUTION
Damage from operating with open chucks
The handpiece or angle piece locks and rotates on its own axis.
▶ Only operate the handpiece or angle piece when the chuck is locked.
5.2.3
Remove the handpiece or angle piece
CAUTION
Damage from changing the handpiece and angle piece during operation.
Wear to the catch on the handpiece and angle piece and the motor
Unbalanced motor axis.
▶ Change the handpiece and angle piece only when the motor not running.
Note
Prevent to coolant hose from dripping on the motor. Coolant may not penetrate the
motor.
▶ Remove the coolant hose from the handpiece or angle piece.
▶ Twist the handpiece or contra-angle handpiece slightly while pulling it off.
See also: 5.1.1 Start up, Page 25
5.2.4
Start the motor
▶ Start the motor. Press the slide pedal and change the speed by moving it the
side. Left stop: minimum speed; right stop: maximum preselected speed. When
the slide pedal is no longer actuated, the selected speed is set on the multifunc‐
tional foot control. Repress the slide pedal to retrieve the last selected speed.
See also:
5.3.3 Preset the speed range, Page 30
5.4.4 Set parameters, Page 36
Note
When the hinged pedal is pressed in an unchanged position (to the side), the last
selected position with an assigned motor speed is retrieved. The motor immediately
runs at the assigned speed. After the program step changes, check the speed
setting, and move the hinged pedal to the required position before pressing.
Instructions for use INTRAsurg 300 / INTRAsurg 300 plus
5 Operation | 5.2 Surgical motors
27/66
