Kärcher ICC 2 Euro 3, Manual

Page: 38 / 308

38
English
Î Raise waste container.
Î Insert the hose on the drain screw.
Î Turn the drain screw by one rotation.
Î Keep a suitable catch bin ready.
Î Close the release screw.
Î Raise waste container.
Î
Loosen the fasteners of the air filter cas-
ing.
Î Remove covering lid.
Î Remove and clean the filter cartridge.
Î Insert new filter cartridge, if required.
Î Clean the screw cap.
Î Replace the screw cap and clamp it.
Î Fix the fasteners of the air filter casing.
Î Grease the left end right lubrication nip-
ples of the front axle.
Î
Grease the left end right lubrication nip-
ples of the rear axle.
Î Grease the lubrication nipple at the
swivel joint.
Î Grease the lubrication nipple at the
steering cylinder.
Î Grease the lubrication nipple at the
steering cylinder.
Î Grease the lubrication nipple at the
brush-system (8x).
Only 4-brush system:
Î Lift the covering flaps at the swivel
heads.
Î Grease the swivel joints (8x).
Only 4-brush system:
Î
Lift the covering flaps at the swivel
heads.
Î Grease the swivel joints (8x).
The central lubrication unit automatically lu-
brications all the lubrication points at speci-
fied intervals.
Note
It is necessary to do an additional round of
greasing after the appliance has been
cleaned thoroughly.
Î Press the button on the central lubrica-
tion unit.
The central lubrication unit will not lubricate
the brush-system.
Î Check the V-Belt of the spray-water
pump for damage and wear and tear.
Î Raise waste container.
Î Check the V-Belt of the lighting system
for damage and wear and tear.
Î Refill water for the wiper.
Emptying the water separator of the fuel
system
Cleaning and replacing the fuel filter
Greasing the bearings
Greasing the brush-system
Central lubrication unit (accessory)
Checking the V-Belt
Refilling wiper water