![background image](http://html1.mh-extra.com/html/karcher/icc-2-euro-3/icc-2-euro-3_manual_3731318033.webp)
English
33
Î
Connect the suction nozzle to the suc-
tion hose.
Î
Set the dry run speed to approx. 1800 1/
min.
Note
The motor rpm can be called via the multi-
functional display.
Î
Turn on the working hydraulics (1st lev-
el).
Î
Press switch for raising the suction
mouth.
– 1. step = raise the suction opening
– 2. step = switch on/off the side-brushes
Î
Raise waste container.
Î
Cover the suction pipe with a plate
when sucking in leaves.
Î
Lower waste container.
Î
Shift the water supply from sweeping to
leaf suction operations.
Î
Turn on the suction turbine (1st level).
Î
Switch on the spray water.
Î
Adjust the water flow using the valve.
Î
Remove the covering on the suction
pipe.
Î
Shift the water supply from leaf suction
to sweeping operations.
몇
Warning
The appliance must be secured against
slippage during transport.
Î
Turn ignition key to "0" and remove it.
Î
Lock parking brake.
Î
Secure the wheels of the machine with
wheel chocks.
Î
Secure the appliance with tension
straps at the fastening eyes on the left
and the right.
몇
Warning
Risk of damage! The front towing eye
should not be used to fasten the appliance.
Danger
When carrying out rescue work on public
highways, wear warning clothing when
working close to passing traffic.
Danger
The hydro-static drive of the sweeper per-
mits towing out of the danger area only for
a few metres at walking speed. Do not
move the sweeper at a speed higher than
walking speed.
Danger
The appliance is not suitable for crane load-
ing.
Note
Make sure the brush-system is not dam-
aged while towing.
Î
Drain off spray water.
Î
Empty waste container.
Î
Fasten the towing rope to the towing
eye in the front or the rear.
Î
Drag the appliance on to the transport
vehicle.
Note
It is easier to move the appliance when the
bypass valve is opened.
Î
Open the bypass valve using the hand
gear from the tool box or a flat spanner
(SW 9).
If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
Î
Park the sweeper on an even surface.
Î
Raise the side-brushes to prevent the
bristles from being damaged.
Î
Turn ignition key to "0" and remove it.
Î
Secure sweeper to prevent it rolling
away, lock parking brake.
Î
Tank up the fuel tank fully.
Î
Change the engine oil and the oil filter.
Î
Drain off the spray water if frost is ex-
pected and check whether is adequate
anti-frosting agent in the cooling water.
Î
Empty the water tank and the pipe sys-
tem.
Î
Disconnect battery.
Î
Charge battery approx. every 2 months.
Î
Clean the inside and outside of the
sweeper.
Î
Park the machine in a safe and dry
place.
Î
First switch off the appliance and re-
move the ignition key before performing
any cleaning or maintenance tasks on
the appliance, replacing parts or switch-
ing over to another function.
Î
Pull out the battery plug or clamp the
battery while working on the electrical
unit.
– Maintenance work may only be carried
out by approved customer service out-
lets or experts in this field who are famil-
iar with the respective safety
regulations.
– Mobile appliances used for commercial
purposes are subject to safety inspec-
tions according to VDE 0701.
Î
Park the sweeper on an even surface.
Î
Empty waste container.
Î
Raise the suction opening and the side-
brushes.
Î
Lock parking brake.
몇
Warning
Risk of damage! The electrical components
in the engine room should not be cleaned
using a high-pressure jet.
The appliance must be cleaned daily after
finishing work.
Note
Do not use aggressive cleaning agents.
After leaf suction operations
Transport
Towing
Bypass valve (accessory)
Shutdown
Maintenance and care
General notes
Cleaning
Cleaning the appliance
Summary of Contents for ICC 2 Euro 3
