Kärcher 2.200-000.0, Manual

Page: 24 / 318

24 English
Check/clean the water filter
1
Casing
2
Water filter
3
Seal
1. Open the left-hand door.
2. Visually check the water filter externally for soiling.
3. For removing the water filter:
a Close off the water inlet.
b Unscrew and remove the casing.
c Check the seal and replace if necessary.
4. Clean the water filter and replace if necessary.
5. Install in the reverse order.
6. Open the water inlet.
Refilling oil in the high-pressure pump
몇 CAUTION
Risk of burns!
Allow the high-pressure pump to cool down before refilling with
oil.
ATTENTION
Check the oil level when the high-pressure pump has cooled
down.
1
Oil filler opening
2
Sight glass
1. Check the oil level at the sight glass and refill with oil if neces-
sary.
Oil type 15 W40.
2. Unscrew the cap from the oil filler opening.
3. Refill with oil.
4. Screw the cap onto the oil filler opening.
Help with errors
You can rectify minor faults yourself using the following overview.
If in doubt, please consult the authorised customer service.

DANGER
Risk of electric shock
Turn off the appliance and remove the key prior to any care and
maintenance work.
Repair work and work on the electrical components may only be
performed by an authorised Customer Service.
Malfunction Cause Remedy
Battery malfunction indicator
lights up  Battery is not charging  Contact Customer Service
Detergent container warning
light lights up  Detergent container empty
Note
The burner switches off
 Refill with RM 110 liquid softener
The burner does not start up

Fuel canister empty
 Blower switch switched off

Refill Diesel
 Switch on the blower switch
Burner emitting sooty smoke

Burner incorrectly adjusted or dirty
 Fuel solenoid valve defective
Note
Diesel fuel continues dripping

Contact Customer Service
 Contact Customer Service
White smoke emitted from the
burner  No ignition spark present (visible
through the sight glass in the burner
cover)
 Condensation in the nozzle carrier

Fuel pressure too low
 Contact Customer Service
 Contact Customer Service

Contact Customer Service
Working pressure fluctuates  Leaks in the high-pressure pump suc-
tion area
 Water filter dirty
 Check the piping system

Clean/replace the water filter
High-pressure pump not build-
ing up pressure

Nozzle clogged/washed out
 Vehicle engine speed too low
 Supply line to high-pressure pump leak-
ing or clogged

Safety valve leaking

Clean/replace the nozzle
 Select the correct engine speed
 Have this checked by Customer Service
 Have the setting and seals checked by Customer Ser-
vice
High-pressure pump knocking  Supply lines to high-pressure pump
leaking  Check and contact Customer Service if necessary