Telephone: 1 (450) 444-2030
•
Toll free: 1 (888) 222-1560
•
Fax: 1 (450) 444-2029
•
Internet: www.kantech.com
2006 Tyco Safety Products, Canada, Ltd. All rights reserved
•
Specifications may change without notice
page 20 of 39
DN1656
-
0606
Configuring the EntraPass DHCP IP Address (LAN)
You have determined that the EntraPass DHCP server will automatically assign IP addresses for
communication with the KT-NCC controller(s).
IMPORTANT :
You will use the EntraPass DHCP server only when there is no other DHCP server on
the local network in order to avoid serious network conflicts.
To configure an EntraPass DHCP Address (LAN)
Six steps are required to configure the KT-NCC in a local network with a DHCP address:
•
Initialize the KT-NCC in factory reset mode;
•
register the KT-NCC on the EntraPass Global Edition server;
•
activate the EntraPass DHCP;
•
configure the KT-NCC in EntraPass Global Edition;
•
connect the KT-NCC to the network;
•
check the connection status.
Initializing the KT-NCC in Factory Reset Mode
A factory reset will delete the entire configuration of the KT-NCC, including the IP address. It is advisable to
reinitialize the KT-NCC before starting the configuration.
Figure 7: Configuration Diagram of the EntraPass DHCP IP Address - LAN
EntraPass DHCP Server
KT-NCC
Ethernet Port #1
1 MAC Address: 00-50-F9-_____-_____-_____
2 IP Address: ______.______._______.______
3 Subnet Mask: 255.255.255.0
OR: ____.____.____.____
4 Port: 18710
OR: ________________
Switch
