Kaba Saflok SYSTEM 6000, Reference Manual

Page: 119 / 132

System 6000
TM
Reference Manual_Section 6
© SAFLOK
Page 20 of 34
06/11
6.8 Diagnostics Error Codes
LPI Programming Errors
If an error occurs when a lock is being programmed, the LPI Terminal will display the following screen indicating an
error code on the Error Line:
* * * LPI ERROR XXX * * *
Error Occurred When Sending Key Level xx, Type yy, xxxxxxxxxx
LOCK AND PROBE COMMUNICATIONS HAVE BEEN TERMINATED
(PRESS Any Key)
The code number indicated on the Error Line is the same as that used by LED Diagnostics and you can refer to the
codes in this section for information about the problem. For LPI Programming errors, you will need to contact
SAFLOK for assistance, and your SAFLOK representative will need this error code information.
Most Common Diagnostics Error Codes
The following error codes are most likely to appear when performing LED Diagnostics:
Code Description
113 All Keys: The key is not valid in the current lock mode or cycle. If LED Diagnostics is on, turn off.
Lock is typically in an invalid mode. Refer to Section 3, Invalid Mode Indicators for additional
information. This code may also appear if you use Standard or Display keys when the PPK or SPK
LEDs are flashing.
117 Standard, Special, PPK and SPK Keys: the lock is in shutdown cycle because 10 or more invalid
keys were used. A valid key must be used to terminate shutdown mode.
122 Standard Keys: Lock is non ‐ operating for this key type. The key does not belong to this lock.
123 Standard and Special Keys: Key is not mastered into the lock. The key does not belong to this
lock.
127 Standard Keys: Key does not have one of the 12 valid Pass numbers required for the Pass
function.
128 Standard and Special Keys: Key is an old key; its new key date is earlier than the lock’s key data.
Replace the key with a current or new key.
129 Standard and Special Keys: Key is an old key; its new key time is earlier than the lock’s key data.
Replace the key with a current or new key.
134 Standard and Special Keys: Key is an old key: Key type has limited sequence range (1 ‐ 15) but
key’s sequence number is older than the lock’s key data. Replace key with a current or new key.
Use a re ‐ sequence key if necessary.