• The cable seal with single groove must be used for the SFP interface cables, and the one
with three grooves must be used for the RJ-45 interface cables.
• Ensure that each groove on the rubber cable seal accommodates only one cable through
it.
• Leave at least 2 in. (5 cm) of interface cable for connecting it to the transceiver.
• Leave in place the hole-plugs for the unused cable seal groove holes.
Figure 52: Installing the ACX500 Outdoor Router Cable Seal on the Interface Cable
1
—
Interface cable
3
—
Rubber cable seal with grooves
2
—
Outer cover of cable seal
4
—
Hole-plugs
7.
Repeat steps
5
through step
6
for the remaining RJ-45 interface cables, as required. Leave in place
the hole-plugs for the unused cable seal groove holes.
8.
Push back the cable seal enclosing the interface cable back into the cable connector unit.
9.
Provide enough cable slack to reach the connector.
154
