Johnson & Johnson ASP STERRAD 200, User Manual

Page: 78 / 85

5
Routine Maintenance
76 STERRAD
®
200 User’s Guide
4. Feed the edge of the paper into the slot behind the printer. Press the Paper
Advance button on the door until the mechanism begins to pull the paper.
Continue pressing Paper Advance until about 150 to 160 mm (6 inches) of
paper exits the printer cartridge.
Figure 39. Feed the paper up through the mechanism and then
through the slot in the door.
5. Feed the printer paper through the slot in the access door and close the door.
Cleaning the Sterilizer
The outside surfaces of the sterilizer can be cleaned with water and a mild
detergent. The inside of the sterilization chamber does not normally require
cleaning. The chamber door and the chamber should not be cleaned with an
abrasive, such as a wire brush or steel wool. If you have any questions regarding
cleaning the STERRAD 200 Sterilizer, call your ASP service representative.
CAUTION: Do not clean the chamber door area with
abrasives. The sterilization chamber uses an O-ring
vacuum seal to maintain a vacuum in the chamber.
Never use rough cleaning tools, such as a wire
brush or steel wool on the door housing or cham-
ber assembly. This could damage the seal. Use a
damp, lint free cloth to clean the chamber door.