Johnson & Johnson ASP STERRAD 200, User Manual

Page: 76 / 85

5
Routine Maintenance
74 STERRAD
®
200 User’s Guide
Maintaining the Printer
The printer requires that the ribbon cartridge be replaced whenever the print
becomes too light to read easily. The paper should be changed when the colored
bars begin to appear on the paper. This indicates the paper supply is running
low.
Replacing the Printer Ribbon Cartridge
To replace a printer cartridge do the following:
1. Open the printer access service door on the upper left.
2. Remove the used cartridge by firmly, but carefully, pulling on the right side,
as indicated by the arrow on the cartridge.
3. Discard the used cartridge.
4. Insert a new cartridge by aligning the left side of the cartridge in the printer.
Push on the right side of the cartridge to snap it into place.
Figure 36. Tilt the ribbon cartridge into position and snap it in place.
5. Turn the knob on the cartridge clockwise to remove any slack from the
ribbon.
6. Feed the printer paper through the printer paper slot in the service door and
close the printer access service door.