112 - 13
Section F
9803/3280
Section F
112 - 13
Issue 2*
Synchro Shuttle Gearbox
Assembly (cont'd)
A397010
A388270
44
If the gear lever turret assembly has been dismantled,
apply grease liberally to the working surfaces before
assembling. Assembly is the reverse of the procedure
detailed in
Gearbox - Dismantling
, Step 1, but note the
following:
a
Be sure to locate the slots in the levers
A
with the
pegs
B
in the housing
E
.
b
After fitting spring
C
, rotate it so that the end of the
bottom coil butts with the the spigot
D
in the
housing
E
.
45
Locate a new gasket (not shown) on the casing followed
by the gear lever turret baffle plate. Make sure the plate
is the correct way round.
45
46
46
Locate a second gasket and then fit the turret
assembly.
Apply JCB Threadlocker and Sealer to mounting bolts
and tighten to 56 Nm (42 lbf ft). Check for gear
selection.
A
D
C
E
B
*
A
B