________________________________________________________________________________________________________________________________________________________________
CN3600 Setup & Operation Manual Revision : 6/2020
41
4. MACHINE OPERATION
4.1 OPERATOR SAFETY
PLEASE NOTE FOLLOWING BEFORE COMMENCING OPERATION:
Safety should be a constant concern of everyone around any type of machinery.
While more than normal precautions were taken in the manufacture of this
machine, everyone connected with its operation should be made fully aware of
the
High Voltages, High Speed Motion
and
Sharp, Rotating Automatically
Actuated Cutting Tools
involved.
To prevent injury, the suggestions below should be followed:
1.
KEEP CLEAR
of cutting blade, rotating mandrel, chuck and material when the
machine is in motion.
2.
ENSURE
all
GUARDS
in position & safety systems operational before starting
the machine..
3.
DO NOT
place your hands between the knife and rolls when loading or
unloading.
ENSURE
knife is in its furthest back position.
4.
KEEP
the area around the machine
CLEAN
and
DRY
. Use slip proof surface
or mats. Only the operator to work within area designated by hazard tape.
5.
ENSURE
main isolator is switched
OFF
before any maintenance is carried out.
6.
ALWAYS
fit rubber guard over knife edge or remove knife when cleaning
machine to prevent injury
.
7.
USE
suitable
PROTECTIVE GLOVES
when handling blades.
8. Request
ASSISTANCE
when
CHANGING
large knives or
LOADING
heavy
material onto the mandrel.
9. A DVD is provided to demonstrate safe operation of this machine.
Ensure you have viewed and understood this before operating this
machine.
Ensure only qualified electricians work on the electrical components of the
machine. Operators must not open the electrical cabinet, motor drive
cabinet or operator panel. In the case of an electrical malfunction qualified
electrical personnel/contractor should be called.
