________________________________________________________________________________________________________________________________________________________________
CN3600 Setup & Operation Manual Revision : 6/2020
31
3.5 KNIFE CARRIAGE
– TRAVERSING LEFT & RIGHT
3.5.1 SETTING LEFT & RIGHT CARRIAGE STOP
The knife carriage traverses by means of a precision Ballscrew, Servo Motor and Controller.
CAUTION:
Ensure knife is clear of log roll before traversing
Scroll to
Screen 5/Left/Right Carriage Stop
Load log roll onto mandrel & secure
Raise mandrel support arm and close
guard
Press FAST/SLOW SPEED
Using H/Held Module (
←) move knife
carriage to first cut position ..
Press LEFT STOP ENTER
Press FAST/SLOW SPEED
To verify L/H stop position exit Screen 5
& move knife carriage right about 50mm
and Left again using traverse arrows on
H/Held Module. Carriage should stop at
first cut position.
Using H/Held Module (
→) move knife
carriage right to last cut position
Press
RIGHT STOP ENTER
NOTE: Above settings are not set until
you exit above screen.
Exit Screen 5 & confirm correct stop
position using arrows on Hand/Held
Module.
