________________________________________________________________________________________________________________________________________________________________
CN3600 Setup & Operation Manual Revision : 6/2020
38
3.11 SAFETY GUARDS
3.11.1 POLYCARBONATE GUARD
The polycarbonate guard fully encloses knife, mandrel and chuck area to protect the
operator from moving parts while the machine is operating.
When the polycarbonate guard is in its raised position, the chuck will not run and the
machine will not operate.
Machine will stop when cover is lifted. (see
Fig. 3.11.1
)
3.11.2 SIDE ACCESS DOOR
The L/hand side door (see
Fig. 3.11.2
) and the expanding section of the mandrel are
both controlled by a manually operated switch on the operator control panel.
3.11.3 REAR HATCH DOOR & SLIDING DOORS
As a safety precaution the rear hatch door (see
Fig. 3.11.3
) and sliding doors (see
Fig.
3.11.4
) are also fitted with safety switches, which will shut the machine down when
opened.,
NOTE:
Machine will not operate if guards are opened.
Note:
When cleaning the polycarbonate guards use only warm soapy water or water
based window cleaner and a soft cleaning cloth.
DO NOT SCRUB
.
Dry with soft cloth.
Under
NO
circumstances should petroleum/gasoline based products be used,
Fig 3-11-2
L/Hand Side door
Fig 3-11-3
Rear Hatch Door
NOTE:
Safety Interlock
switches prevents
machine start up
when guards open
Fig 3-11-1
Safety Guard Front
Fig 3-11-4
Rear Sliding Doors
Hatch Door used
only when
sharpening knife
in Manual Mode
