![background image](http://html.mh-extra.com/html/javelin/cn3600/cn3600_setup-and-operation-manual_635546030.webp)
________________________________________________________________________________________________________________________________________________________________
CN3600 Setup & Operation Manual Revision : 6/2020
30
3.4.2.2 Knife Adjustable Rear Stop:
CAUTION
If the knife or the log roll diameter is increased the forward and rear stop setting must be
adjusted.
•
Load log roll on mandrel.
•
Operate Door Close/Mandrel Grip Switch
•
Raise mandrel support arm and move knife just past left hand end of log roll.
Scroll and return to Screen 2
Knife & Carriage Settings
and press KNIFE ADJ REAR STOPto go
to
Screen 4/Knife Adjustable Rear Stop
Press FAST MOVEMENT to move Knife
forward in High Speed using H/H
Module(
↓) to a position where the knife
has 10-20 mm clearance from the outside
diameter from the log roll (Distance
dependant on tape thickness (Foam)
and/or roll being out of round.
Press ENTER SETTING on screen.4
Knife will automatically retract to rear
position.
To verify ‘Adj Rear Stop’ position
Press on Hand Held Module
‘for two to three seconds & release
Knife should move forward to 10-20mm
away from O/D of roll
Setting varies with O/D of knife - Typical
Setting when using 400mm O/D knife: 98.5
Note: This distance must be less than that set
on Screen 3 (Knife Forward Stop)
If a greater distance is entered an Error Code
alarm will sound and the machine will not
operate.