CNC Base machinery / CNC machinery: Type FlatCom
Assembly instruction / Operating instruction for FlatCom Series M, L and XL
page 50
13.1
Declaration of Conformity for Machinery
EC Declaration of Conformity corresponding Machinery Directive 2006/42/EU, Annex II A
The manufacturer
isel Germany AG
Bürgermeister-Ebert-Straße 40
D-36124 Eichenzell
declares hereby, that the following product
Product designation:
CNC-Machine FlatCom
Types:
FlatCom Series M,
article number: 2750x3, x=2,3,4,5
FlatCom Series XL,
article number: 27455x 001y, x=2,3,4,5,6 y=1,3,4
conforms to the safety and health requirements of the
Machinery Directive 2006/42/EU, Annex I
– including
those at the time of declaration current alterations.
The following harmonized Standards have been applied:
EN ISO 12100-1:2003
Safety of machinery
– fundamental terms, general principles of design – Part
1: Basic terminology, methodology
EN ISO 12100-2:2003
Safety of machinery
– fundamental terms, general principles of design – Part
2: Technical principles
EN ISO 13857:2008
Safety of machinery
– Safety distances to avoid reaching of dangerous
regions with upper and lower extremities
EN 349:1993
Safety of machinery
– Minimum distances to avoid bruising of parts of the
body
EN 953:1997
Safety of machinery
– Guards – general requirements for the design and
construction of fixed and moveable guards
EN 954-1:1996
Safety of machinery
– Safety related parts of control systems,
Part 1: General principles for design
EN ISO 13850:2008
Safety of machinery
– Emergency-Halt – Design guidelines
EN 14121-1:2007
Safety of machinery
– Risk assessment – Part 1: Guidelines
EN 60204-1:2006
Safety of machinery
– Electrical equipment of machines,
Part 1: General requirements
Also the following EU Directives have been applied:
EMV Directive
2004/108/EU
Low Voltage Directive
2006/95/EU
The
technical documentation
for this machine was created corresponding Annex VII Part A. The
manufacturer obligates to provide the technical documentation in electronic mode on demand of authorized
governmental agency.
Representative
for composition of technical documentation is:
Helmut Danz
Place, Date:
Dermbach, 4.01.2010
_____________________________
Werner Kister, Managing Board
