CNC Base machinery / CNC machinery: Type FlatCom
Assembly instruction / Operating instruction for FlatCom Series M, L and XL
page 21
6 Initial operation
6.1
Preliminary
6.1.1 Operating elements
The following figure shows the operating elements on the CNC control panel. The use of
each single element is explained in chapter 6.4.
CNC control panel
6.1.2 Coordinate system and work piece zero point
The coordinate system of the CNC machine
is set as a right system as shown in the
picture.
The
work piece zero point
P0 can be
defined by the software (e.g. via teach in) or
is freely programmed in the application
program.
A
yellow
label on each axis marks both the
axes (X, Y or Z as axis letter for linear axes,
A, B or C as axis letter for rotation axis) as
well as the positive / negative axis direction
of linear axis resp. positive / negative
rotation direction or rotation axis.
If you need to change the arrangement of the coordinates, please read
the manuals for the motor power amplifiers IMD10 /1.1/, IMD20 or IMD40
/1.2/ or contact our technical support.
