4
Maintenance and adjustment
90
the rear of the switch assembly.
To replace the bulb:
1. Remove the switchs (Fig. 65)
2. Remove the wiring plugs from the
switch with the failed bulb.
Fig. 65:
3. The switch is retained by a sprung tag (1
Fig. 66) at either end. Press in the tags
4. To change the bulb, press in tag (2 Fig.
66) using a small screwdriver and pull
the bulb retainer (3) from the back of
the switch. and remove the switch as-
sembly.
5. The bulb (4) is of the capless type, and
is a push fit in the retainer.
6. After changing the bulb, push the re-
tainer into the back of the switch until
the tag locates in the aperture.
7. Replace the switch, plugs and panel.
Fig. 66:
1
2
3
4
Direction indicator warning lights
(Fig. 67)
1. Remove the right hand lower instru-
ment panel as described above.
2. Remove the two plugs.
3. Press in the two tags (1) to remove the
light (2) from the panel.
4. Ease the bulb holder (3) to the right
and pull.
5. The bulb (4) is of the capless type, and
is a push fit in the retainer.
6. After changing the bulb, push the re-
tainer into the back of the switch until
the tag locates in the internal grove.
7. Replace the light holder, plugs and
panel.
Fig. 67:
3
2
1
4
Summary of Contents for ITM 475
