Intermec Janus 2050, User Manual

Page: 28 / 419

39
nugget
A Getting Started
1-7
1
•
Allow space to access the back panel connectors and the ON/OFF switch.
When you mount the JANUS 2050 on metal surfaces, the minimum
reinforced thickness should be 10-gage (3.4mm) steel.
•
Intermec recommends fastening a bolt (3/8-inch/10mm) with a flat washer,
lock washer, and nut (3/8-16 UNC-2B) to each of the four corner holes on
the mounting bracket. The bolt length will depend on the thickness of the
mounting surface.
•
Attach the power cable to the JANUS 2050 and leave a 6-inch service loop
in the cable. Use plastic tie-wraps to secure the cable all the way to the
power connection. Make sure the cable will not be pinched or rubbed by
any moving parts on the vehicle. In some applications, you may need to
sheath the cable to prevent it from being pinched.
Note: Mounting hardware (bolts, nuts, and washers) is not supplied with the
JANUS 2050.
To attach the mounting bracket to the vehicle
1. Using the mounting bracket as a template, mark and drill four holes in the
mounting surface.
2. Attach the bracket using a bolt (3/8-inch/10mm) with a flat washer, lock
washer, and nut (3/8-16 UNC-2B) through each of the four holes in the
mounting bracket and the mounting surface.
After you secure the mounting bracket to the vehicle, attach the JANUS 2050 to
the mounting bracket.
To attach the JANUS 2050 to the mounting bracket
1. Place the split lock washers on the knobs.
2. Insert the knobs through the mounting bracket and thread into the JANUS
2050.
3. Secure the grounding cable to the mounting bracket with a
nut (8-32 UNC-2B).