Intermec Janus 2050, User Manual

Page: 127 / 419

JANUS 2050 Vehicle-Mount Computer User’s Manual (4MB) 39
nugget
A
5-16
6. Search for this line in the CONFIG.SYS file:
device=d:\cardid.exe d:\cardid.ini
If the line is remarked out, delete the REM characters. If you cannot find
this line, add it to the CONFIG.SYS file.
7. To save conventional memory, remark out any lines that load drivers for
ATA, flash, or SRAM cards.
8. Save your changes to the CONFIG.SYS file.
9. Replace the AUTOEXEC.BAT and CONFIG.SYS files on the JANUS
drive C.
Resetting the PC Card Drive for I/O Cards
By default, the PC card drive is not reset when you suspend or resume the
JANUS device. Therefore, you can keep files open when you suspend and
resume without losing data.
However, if you have an I/O card in the PC card drive, you must reset the
drive when you resume the device. You can configure the device to reset the
drive after a suspend/resume cycle by running the APM_4M.EXE program.
To load APM_4M.EXE into memory
• Type this command at the DOS prompt:
d:\apm_4m
Or scan this bar code:
*D/Z%LAPM%O4M*
*D:\APM_4M*
You can add this command to your AUTOEXEC.BAT file to start
APM_4M.EXE whenever you boot the reader:
d:\apm_4m.exe
Note: APM_4M.EXE is also available on the Application companion disk 3.
Preparing to Use SRAM Cards
To use an SRAM card you need to:
1. Configure the JANUS 2050 to use an SRAM card by selecting the SRAM
card option on the MS-DOS Startup menu.
2. Format the SRAM card.
3. Use the SRAM card.