Intermec Janus 2050, User Manual

Page: 351 / 419

JANUS 2050 Vehicle-Mount Computer User’s Manual (4MB) 39
nugget
A
A-28
Configuration Commands by Syntax (continued)
Syntax Command
IEdata Timeout delay
IFdata LRC
IGdata Turnaround delay
IHdata Transmit abort timeout
IIdata Data bits
ILdata Flow control
ISdata Communications port, select
IVdata Communications port 1, UART restore FIFO control register
IWdata Communications port 2, UART restore FIFO control register
IXdata Communications port, scanner on COM2
KAdata Keypad Caps Lock
KBdata Keypad Ctrl key functions
KCdata Keypad click
KDdata Keypad, numeric
NM02data RF loopback
NM03data RF broadcast receipt
PAdata Communications protocol, activate
PCdata RES (Reset)
PDdata REQ (Request for Acknowledge)
PEdata SOM (Start of Message)
PFdata EOM (End of Message)
PGdata AFF (Affirmative Acknowledge)
PHdata NEG (Negative Acknowledge)
PIdata Transmit EOM
PJdata Receive EOM
PMdata Communications protocol, User-Defined Multi-Drop
PSdata Communications protocol, select
R<channel>data RF channel allow
RFdata RF protocol
RHdata RF device address
RLdata RF retry limit
RMdata RF acknowledgment delay
RTdata RFNC (RF network controller) address
RUdata RF repeat count
RVdata RF channel select
RWdata RF network ID
RXdata RF duty cycle period
RYdata RF duty cycle percent
SAdata Scanner timeout
SBdata Scanner mode
SCdata Scanner trigger